To avoid as much fuel leakage as possible, on the new filter leave one of the plugs on and as you take off one end of the hose plug it straight into the new filter, then put the plug that came with the new filter on the old filter. I inserted them in the direction of the filter end of the hoseclip.īefore you take it out make note of which direction the filter is installed. Instead I used two small flat screwdrivers and inserted them into the two larger holes on each side of the hose-end clip. A Pod Filter On A Vt Commodore Drivers And Inserted To remove the hoses some people say to squeeze them, possibly using pliers, and that they break easy. The filter is held in place with a plastic clip which is easy to remove, but you are probably best leaving that until after the hoses have been removed. I backed the car up on to ramps so that there was plenty of room to work in, but you dont necessarily need to lift the car at all. I did this by leaving the car running and then pulling out the fuel pump fuse.įirstly, if you arent sure where the fuel filter is located, it is accessible from underneath and behind the car, just next to the differential and on the right side of the car. Optional 8 rib pulley kit and Gilmer rear drive belt kit available.īefore you start on this job you should relieve fuel pressure. A Pod Filter On A Vt Commodore Drivers And Inserted.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |